Multitech RASFinder RF300E User Manual page 123

!D0=n V.120 LLC Information Element
!D3=n SAPI-0 Data TEI
*!D3=n SAPI-0 Voice TEI
!DNn Disable Data DN/MSN n
*!DNn Disable Voice DN/MSN n
!ENn Enable Data DN/MSN n
*!ENn Enable Voice DN/MSN n
!Nn=s Data DN/MSN n
*!Nn=s Voice DN/MSN n
Serial Port Configuration Commands (D.1.4)
&Cn DCD (Data Carrier Detect) Control
&Dn DTR (Data Terminal Ready) Control
$Dn Persistent DTR Dialing
&En Flow Control
&Rn CTS (Clear To Send) Control
&RFn CTS/RTS Interaction Control
&Sn DSR (Data Set Ready) Control
!SW Switch Serial Port Control to TA
*!SW Switch Serial Port Control to Modem
#Xn Send Multiple Xoff Characters
General Configuration Commands (D.1.5)
@CONFIG
En Command Mode Echo
%En Escape Sequence Options
&Fn Load Factory Profile
%Mn Management Mode
Qn Quiet Mode
Sr=n Set S-register
Sr? Read S-register
Vn Terse/Verbose Result Codes
&Wn Store Active Profile
Xn Connect Messages
Zn Reset to Stored Profile
&Zn= Store Telephone Number
!Z=n Rate Adapation/Data Protocol
Digital (Data) Call Commands (D.1.6)
A Answer Digital Call
Dn Dial Digital Number
DSn Dial Stored Number
Hn Hang up Digital Call
!Hn Digital Call Hold-off Time
On Return Online
Analog (POTS) Call Commands (D.1.7)
*An Answer Analog Call
*Bn Send Analog Dial Digit
*Dn Dial Analog Number
*Hn Hang up Analog Call
*!Hn Analog Call Hold-off Time
RF300E/RF310E
Configuration Menu
Appendix D - AT Command Summary
123