Table of Contents
Advertisement
Configuring Your MultiVOIP 200
The following steps provide instructions for configuring your MultiVOIP 200. The configuration sequence includes
IP Protocol default setup, Channel setup, and Phone Directory Database setup. The Phone Directory Database
setup is configured differently depending on whether or not the Gatekeeper function is available and enabled on
the Phone Directory Database dialog box (See Step 26).
11. The IP Protocol Default Setup dialog box is displayed.
The default Frame Type is TYPE_II. If this does not match your IP network, change the Frame
Type by clicking the drop-down arrow and selecting SNAP. The available Frame Type choices are
TYPE_II and SNAP.
12. In the Ethernet group, enter the IP Address, Subnet Mask, and Gateway Address unique to
your IP LAN in the corresponding fields.
The IP address is the unique LAN IP address that is assigned to the MultiVOIP 200, and the
Gateway address is the IP address of the device connecting your MultiVOIP 200 to the Internet.
Click OK when you are finished.
13. The Channel Setup dialog box is displayed. The four tabs in this dialog box define the channel
interface, voice/fax parameters, billing/miscellaneous parameters, and regional telephone
parameters for each channel.
Configure each channel for the type of interface you are connecting to. The Interface tab defaults
to Channel 1 in the Select Channel field. To change the channel number, click the drop-down
arrow and the list of channels is displayed. Highlight the channel you want to configure.
Note: Feature options are enabled or disabled (grayed out) according to the interface type that
you select. The one option available for all interface types is the Inter Digit Time option. This
option defines the maximum amount of time that the unit will wait before mapping the dialed digits
to an entry in the Phone Directory Database. If too much time elapses between digits, and the
wrong numbers are mapped, you will hear a rapid busy signal. If this happens, it will be
necessary to hang up and dial again. The default setting is 2 seconds.
Chapter 3 - Software Loading and Configuration
27
Advertisement
Table of Contents
