Table of Contents
Advertisement
Configuring Your Client MultiVOIP 200s
If the Proprietary Phonebook option on the Phone Directory Database dialog box was enabled,
then you will need to configure all remote H.323 endpoints as "Client" units. For example, the
MultiVOIP 200 at the company's subsidiary office in London would need to be configured as a
"Client."
CAUTION: If you are installing a MultiVOIP 200 behind a Firewall, the Firewall must support H.323.
Refer to your Firewall user documentation to enable H.323 support.
1. Disconnect the PC from the Command port of the Host MultiVOIP 200 and connect it to the
Command port on the Client MultiVOIP 200.
2. Fom your desktop, click Programs I MultiVOIP 200 I MultiVOIP 200 Configuration. The Main
menu is displayed.
3. Click IP to display the IP Setup dialog box.
Click (check) the Enable Diffserv box if you have routers that support Diffserv (sometimes called
IP Precedence). This feature gives priority to voice packets so they are not delayed because of
large data files being downloaded.
The default Frame Type is TYPE_II. If this does not match your IP network, change the Frame
Type by clicking on the drop-down arrow. The Frame Type choices are TYPE_II and SNAP.
4. In the Port Address group, enter the IP Address and IP Mask. In the Gateway Address group,
enter the gateway IP address for the Client unit.
Chapter 3 - Software Loading and Configuration
43
Advertisement
Table of Contents
