Table of Contents
Advertisement
8. Pull the Seat Knob (48) out and slide the Seat
Carriage (44) onto the Rail (4) as shown. Engage
the Knob into a hole in the Rail.
Press the Rail Cap (49) onto the Leg (5). Attach
the Leg to the Rail (4) with two M10 x 64mm
Button Bolts (80), four M10 Washers (106), and
two M10 Nylon Locknuts (103).
9. Attach the Rail Insert (31) inside of the Rail (4)
with two M10 x 64mm Button Bolts (80), four M10
Washers (106), and two M10 Nylon Locknuts
(103). Make sure the Bolts go through the indi-
cated holes in the Rail Insert.
10. Lubricate an M10 x 125mm Button Bolt (89) with
grease. Attach the Rail (4) to the Row Plate (28)
with the Bolt, two M10 Washers (106), two 31mm
Spacers (30), and an M10 Nylon Locknut (103).
Do not overtighten the Locknut; the Rail must
be able to pivot easily.
Tighten the Storage Knob (29) into the Row Plate
(28) and the Rail (4).
11. Wet a Squat Arm (20) with soapy water. Slide a
Small Foam Pad (24) and a Short Handgrip (21)
onto the Squat Arm.
Repeat with the other Squat Arm (20).
Tighten the Squat Knob (27) into the Squat
Carriage (19) and the Squat Arm Pivot Tube (not
shown).
8
103
106
5
9
103
106
4
10
106
103
30
4
11
20
19
9
4
48
44
Holes on
this side
106
49
80
31
Holes
106
106
80
29
28
30
106
89
Lubricate
27
20
24
21
Advertisement
Table of Contents
