Authentication-Mode - HP Enterprise FlexFabric 12900E Series Command Reference Manual

[Sysname-line-aux0] activation-key s
To verify the configuration:
1. Exit the AUX session.
[Sysname-line-aux0] return
<Sysname> quit
2. Log in again through the AUX line.
The following message appears:
Press ENTER to get started.
3. Press Enter.
Pressing Enter does not start a session.
4. Press s.
A terminal session is started.
<Sysname>

authentication-mode

Use
authentication-mode
Use
undo authentication-mode
Syntax
authentication-mode { none | password | scheme }
undo authentication-mode
Default
The authentication mode is password for the VTY line.
The authentication mode for the AUX line is as follows:
•
If the device starts up with the factory defaults, scheme authentication is enabled, which
requires you to use local username admin for login. After you log in, you have the
network-admin user role and must configure a password for local user admin.
•
If the device starts up with the initial configuration, authentication is disabled. To improve device
security, configure password or scheme authentication for console login immediately after you
log in to the device for the first time.
Views
User line view
User line class view
Predefined user roles
network-admin
Parameters
: Disables authentication.
none
: Performs local password authentication.
password
: Performs AAA authentication. For more information about AAA, see User Access and
scheme
Authentication Configuration Guide
to set the authentication mode for a user line.
to restore the default.
.
46