Version Check Ignore - HP Enterprise FlexFabric 12900E Series Command Reference Manual

Predefined user roles
network-admin
Usage guidelines
To make sure the standby MPU always runs the same software images as the active MPU, configure
both the
version auto-update enable
command.
The startup software version check feature examines the standby MPU's startup software images for
version inconsistency with the active MPU's current software images at startup. If their software
versions are different, the standby MPU copies the current software images of the active MPU,
specifies them as main startup software images, and reboots with these images.
To ensure a successful synchronization in a multiuser environment, make sure no one reboots or
swaps MPUs during the software synchronization process. You can configure the information center
to output the synchronization status to configuration terminals (see Network Management and
Monitoring Configuration Guide).
Examples
# Enable software auto-update for the standby MPU.
<Sysname> system-view
[Sysname] version auto-update enable
Related commands

version check ignore

version check ignore
Use
version check ignore
startup.
Use undo version check ignore
Syntax
version check ignore
undo version check ignore
Default
The startup software images on the standby MPU are checked for version inconsistency with the
current software images on the active MPU.
Views
System view
Predefined user roles
network-admin
Usage guidelines
When the standby MPU starts up, this command disables the system to examine the standby MPU's
startup software images for version inconsistency with the active MPU's current software images.
The standby MPU can start up with a different software version than the active MPU.
To avoid anomalies, do not disable startup software version check for the standby MPU unless for
software upgrade.
To make sure the standby MPU always runs the same software images as the active MPU, configure
both the
version auto-update enable
command.
command and the
to disable startup software version check for the standby MPU at
to enable this feature.
command and the
195
undo version check ignore
undo version check ignore