Table of Contents
Advertisement
Introduction
About this manual
This
manual
is
part
of
the
documentation that is structured in a specified
Xerox format.
Organization
The Xerox Document WorkCentre 365c/365cx
Service Manual is the primary document used for
repairing and maintaining the family of products.
The manual contains this information divided into
the following sections:
Section 1
Installation
This section provides the machine installation
instructions. Refer to the Users Guide for
software installation instructions.
Section 2
Repair Procedures
This section contains Repair Procedures.
Use this section to isolate a faulty component
or subassembly.
Section 3
Image Quality Repair Procedures
This section contains Image Quality Repair
Procedures.
Use this section to isolate
common image quality defects.
Section 4
Repair / Adjustment
This section contains the instructions for
removal and replacement of the spared parts
within the machine.
Section 5
Parts Lists
This section consists of illustrations and part
number lists. Any part that is spared or any
part that must be removed to access a spared
part is illustrated.
Document WorkCentre 365c/365cx
Section 6
General Procedures/Information
This section contains general procedures and
product specifications.
multinational
Section 7
Theory of Operation
This section contains illustrations, timing
diagrams, circuit descriptions and lists of the
signals and connectors.
Terminology and Symbols
The following is the terminology and symbols that
are used in this manual for an Electrostatic Device
caution, Laser Warning, and general Warnings,
Cautions, or Notes.
Certain components in this product are susceptible
to damage from electrostatic discharge. Observe
all ESD procedures to avoid component damage.
DANGER
AVOID DIRECT EXPOSURE TO BEAM
Invisible laser radiation
Use of controls or adjustments other than those
specified in this manual may result in an exposure
to dangerous laser radiation. The WorkCentre 385
is
certified
to
Performance Standards set by the US Department
of Health and Human Services as a Class 1
product. This means that it is a laser product that
does not emit dangerous laser radiation during
any mode of customer operation. During servicing,
the laser beam could cause eye damage if looked
at directly. The service procedures must be
followed exactly as written.
www.printcopy.info
comply
with
Laser
Product
12/98
12/98
v
WARNING
Improper operation may result in injury to a
person.
CAUTION
Improper operation may result in machine
damage.
NOTE: Hints or other information that
may assist the user.
Indicates that a surface can be hot. Use caution
when reaching in the machine to avoid touching
the hot surfaces.
Introduction
Advertisement
Chapters
Table of Contents
