Eq Overview Screens Eq概况图像 - PRESONUS StudioLive III Series Owner's Manual

6 The Fat Channel
6.8 Fat Channel Screens
6.8.4.3 Class-A FET Compressor Overview Screen
6.8.5 EQ Overview Screens EQ概况图像
When the Fat Channel is in Class A FET Compressor mode, the Touch Display shows
an overview screen that displays the relevant parameters. Touching any onscreen
knob allows you to use the Master Control encoder to set the selected parameter.
Touching a drop-down selector (such as Key Source) lets you select from a list of
relevant choices. Use the Master Control encoder to scroll through choices. Touching
onscreen buttons toggles the related parameter on or off.
Power User Tip: For StudioLive models with dynamic Fat Channel displays, many of these
parameters can also be controlled from the encoders and buttons in the Fat Channel. See
Section 6.5.3 for details.
1
2
3 4
当 Fat Channel 处于A类FET Compressor 模式时， Touch Display 显示一个概览图
像的相关参数。触屏幕上的任何旋钮，可以使用 Master Control 编码器来设置
所选参数。触控下拉选择器（如键源）可以从相关的选择列表中选择。使用
Master Control 编码器滚动选择。触屏上的按钮，可以打开或关闭相关参数。
Power User Tip: 带有动态 Fat Channel 显示的 StudioLive 型号，许多参数也可以
通过Fat Channel中的编码器和按钮来控制。 详情见第 6.5.3 节 。
Processor On/Off. Enables or disables the Compressor. 启动或禁用Compressor。
1.
2. Input. Sets the input gain to the compressor. 设置Compressor输入增益。
3. Output. Sets the make-up gain for the compressor. 设置Compressor的增益弥
补。
4. Attack. Sets the attack time for the compressor. 设置Compressor的attack time。
5. Release. Sets the release time for the compressor. 设置Compressor的release
time。
6. VU Meter. Displays the post-Compressor signal level. 显示post-Compressor信
号源电平。
7. Ratio. Sets the ratio for the compressor. 设置compressor压缩比率。
8. Key Filter. Sets the Key Filter frequency. 设置Key Filter 键噪滤波频率。
9. Key Listen. Touch to enable the Key Listen function. 触控启动Key Listen功能。
10. Key Source (Input Channels only). Sets the Key Source for the Compressor.
设置Compressor的Key Source。
Note: Because the StudioLive 64S employs the quad-core FLEX DSP engine, any of the first
32 channels can be used a Key Source for channels 1-32 while any of the second 32
channels can be used as a Key Source for channels 33-64.
注意： StudioLive 64S 采用了四核 FLEX DSP 引擎，前 32 channels 中的任何一个都可以
作为通道 1-32 的音源，而后 32 channels 中的任何一个都可以作为通道 33-64 的音
源。
Pressing the EQ button in the Fat Channel gives you access to equalization settings
for the currently selected channel or mix. An EQ (or equalizer) is a tone control that
lets you make changes in the tonal balance of a signal. You can boost or cut the level
5 6
7
StudioLive™ Series III
Owner's Manual
10
9
8
63