Control Network Ip Address; Transport Controls 传输控制 - PRESONUS StudioLive III Series Owner's Manual

9 Master Control
9.4 UCNET
Control Network IP Address Settings 控制网络IP地址设置
9.4.4
Transport Controls 传输控制
9.4.5
In the Control Network area of the UCNET screen, you'll see the current IP address
of your StudioLive. This IP address can be assigned in one of three ways. Select the
necessary IP assignment mode by touching one of the following buttons:
UCNET图像上的Control Network区域，可以看到你的StudioLive的当前IP地址
。分配这个IP地址，可以通过三种方式之一进行。通过触摸以下按钮之一，
选择必要的IP分配模式：
• Dynamic. The IP address is assigned automatically upon connection to the
network, and can shift to a new address when necessary due to changes in
network availability. In this mode, a Renew button is shown onscreen. Touch this
button to renew the DHCP lease for your StudioLive.
IP地址连接网络时会自动分配，必要时，因网络可用性的变化会转移到新
的地址。这种模式下，屏幕会显示一个Renew按钮。按此按钮，为你的
StudioLive，可以更新DHCP租约。
• Static Self (Self-Assigned). The IP address is assigned automatically, but stays
the same thereafter until you need to change it. In this mode, an Apply button is
shown. Touch this button to auto-assign a new static IP address to your StudioLive.
自动分配IP地址，直到你需要改变它，它会保持不变。在这种模式下，
会显示一个Apply 按钮。触摸这个按钮，你的StudioLive会被自动分配一个新
的静态IP地址。
• Static Manual. The IP address can be set manually, and remains the same until it
is changed. In this mode, an Edit button is shown. Touch this button to open the
Static Manual Edit screen, where you can specify IP address, subnet mask, and
gateway settings for your StudioLive as needed for your network configuration.
Touch each field in the form to bring up an onscreen keyboard for entry. When
you're finished entering the settings, press Apply to establish the new settings. To
exit without re-setting IP settings, touch the Cancel button.
IP地址可以手动设置，并且改变之前保持不变。在这种模式下，会显示一
个Edit按钮。触碰这个按钮，可以打开静态手动编辑屏幕，在这里你可以根
据网络配置的需要，为你的StudioLive指定IP地址、子网掩码和网关设置。
触摸表格中的每个字段，会出现屏幕键盘供你输入。当你完成输入设置后
，按 "Apply"来建立新的设置。要退出而不重新设置IP设置，触摸 " Cancel "
键。
While your StudioLive Series III mixer is controlling a DAW, you can chose to have the
Transport section control the SD recorder when DAW mode is disabled, or continue
to control the Transport in your DAW whether or not DAW mode is active.
StudioLive™ Series III
Owner's Manual
88