Table of Contents
Advertisement
Vapor Clean cycle setting
If the indoor temperature is higher than
expected, the function is not activated
and every time the
the appliance makes a beep.
Let the appliance cool down before
activating the function.
1. After entering the special functions menu,
press the
button until the
function is selected.
2. Press the
button to confirm.
3. Fill the tank with clean water until the full
load indicator light
4. At the end, remove the funnel and place the
loading drawer back in its place.
84 - CLEANING AND MAINTENANCE
button is pressed
displays.
5. Press the
button to start the function.
The duration and temperature
parameters cannot be changed by the
user.
At the end,
and a beep is activated.
6. Turn the function knob to position 0 to exit
the function.
Programmed Vapor Clean cycle
It is possible to program the Vapor Clean
function start time, like any cooking function.
7. After selecting the Vapor Clean function,
press the
button.
The
and
indicator lights on the display
flashes.
8. Turn the temperature knob to set the function
end time.
9. Press the
button to confirm.
The appliance waits until the set start time to start
the Vapour Clean function.
Reservoir draining
Before draining the reservoir, wait for
the oven to cool down, leaving the
door open. To make sure that the water
remaining in the reservoir is not too hot,
wait at least 40 minutes.
After Vapor Clean function:
1. Open the door
2. Place the deep pan on the second shelf
from the bottom. Push it against the rear wall
of the oven cavity.
3. From position 0, turn the function knob to the
left by one position. The
The appliance suggests the Drain reservoir
is displayed and flashes
button flashes.
91477A653/B
Advertisement
Table of Contents
