Vfo Scan - Icom IC-V3500 Advanced Manual

SCAN OPERATION
4.

VFO scan

1� Push [V/MHz SCAN] to select the VFO mode�
2� Set the squelch to the point where the noise just
disappears�
3� Hold down [V/MHz SCAN] for 1 second to start
scanning�
• The frequency decimal point and the selected scan
type icon blink�
L When a signal is detected, the scan pauses
according to the Scan Stop timer setting, and then
resumes�
L Push [MONI ANM PA] to stop or resume the scan�
4� Push [V/MHz SCAN] to cancel the scan�
TIP:
• During a scan, rotating [DIAL] changes the
scanning direction�
• Push [SET LOCK] to switch between a Full scan
and a Programmed scan (P1, P2, or P3)�
L P1, P2, or P3 can be selected only when their
Program Scan Edges are entered�
Using the HM-133V microphone
1� Push [VFO/LOCK] to select the VFO mode�
2� Set the squelch to the point where the noise just
disappears�
3� Push [SCAN 2 T-SCAN] to start scanning�
• The frequency decimal point and the selected scan
type icon blink�
L When a signal is detected, the scan pauses
according to the Scan Stop timer setting, and then
resumes�
L Push [MONI 1 ANM] to stop or resume the scan�
4� Push [SCAN 2 T-SCAN] to cancel the scan�
TIP:
• You can also start scanning by holding down [▲]
or [▼] for 1 second.
• Push [SET B D-OFF] to switch between a Full
scan and a Programmed scan (P1, P2, or P3)�
Example: Starting a Full scan.
Push [V/MHz SCAN] to select the VFO mode�
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE M/CALL
Hold down [V/MHz SCAN] for 1 second to start
scanning�
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE M/CALL
Example: Starting a Full scan.
Push �
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE M/CALL
Push �
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE M/CALL
4-4
PRIO SCAN
V/MHz
"�" and "AL" blink�
PRIO SCAN
V/ MHz
PRIO SCAN
V/MHz
"�" and "AL" blink�
PRIO SCAN
V/ MHz