Icom IC-V3500 Advanced Manual page 79

10. PROGRAMMING
Programming operation
The transceiver has a data copying capability� This function is useful for copying all of the settings and entered
contents from one transceiver to another�
You can also program data from a PC to a transceiver, using the optional CS-V3500 programming software�
DCloning between two transceivers
An optional OPC-474 programming cable is
required�
1� Connect the master and sub-transceivers using
the OPC-474 through their [SP] jacks�
• The master transceiver is used to send data to the
sub-transceiver�
2� Turn ON the sub-transceiver�
3� While holding down [M/CALL PRIO], hold down
[ ] for 1 second to turn ON the master transceiver
and enter the Cloning mode�
• "CLONE" is displayed�
4� Push [S�MW MW] on the master transceiver to
start cloning�
• "CL OUT" is displayed on the master transceiver's
display, and the S/RF meter shows that data is being
transferred to the sub-transceiver�
• "CL IN" is displayed on the sub-transceiver's display,
and the S/RF meter shows that data is being received
from the master transceiver�
• When the cloning is finished, the master transceiver
returns to the cloning mode screen, and the sub-
transceiver displays "CL OK�"
5� Turn OFF both transceivers, and then turn ON the
transceivers again to exit the cloning mode�
NOTE: DO NOT push any key on the sub-
transceiver while cloning� This will cause an error�
When "CL NG" is displayed, a cloning error has
occurred�
In this case, follow the cloning procedures again�
MUTE
NAR
MID
LOW
LOCK ANM
Cloning error
PRIO AO
To the [SP] jack
The master transceiver
While holding down [M/CALL PRIO], turn ON the
transceiver�
[ ]
PRIO AO
MUTE
NAR
MID
LOW
LOCK ANM
Push [S�MW MW] to start cloning�
[S�MW MW]
PRIO AO
MUTE
NAR
MID
LOW
LOCK ANM
The sub-transceiver
PRIO AO
MUTE
NAR
MID
LOW
LOCK ANM
PRIO AO
MUTE
NAR
MID
LOW
LOCK ANM
10-2
To the [SP] jack
OPC-474
[M/CALL PRIO]
During cloning mode
While cloning
While cloning
The cloning is completed�