Icom IC-V3500 Advanced Manual page 8

1 ADVANCED OPERATIONS
Temporary Volume function
You can set a specific volume level between 0 and 32
Once [BANK OPT] is pushed, the volume level is
changed to the set value
DAssigning the Temporary Volume
function to [BANK OPT]
1 While holding down [SET LOCK], hold down [ ]
for 1 second to enter the Initial Set mode
2 Repeatedly push [SET LOCK] or [MONI ANM PA]
to select "OK" ([BANK OPT] key)
3 Rotate [DIAL] to select "TVo"
4 Push [ ] to save and exit the Initial Set mode
DSetting the Temporary Volume
1 While holding down [SET LOCK], hold down [ ]
for 1 second to enter the Initial Set mode
2 Repeatedly push [SET LOCK] or [MONI ANM PA]
to select "TV" (Temporary volume)
3 Rotate [DIAL] to set the volume level
4 Push [ ] to save and exit the Initial Set mode
NOTE: You can use the function as "One-Touch Mute"
by setting volume at level 0
DUsing the Temporary Volume function
IMPORTANT: When another function is assigned to
[BANK OPT], this function cannot be used
z Push [BANK OPT]
• The volume level is changed to the set value
• "VOL" and the changed volume level is displayed
L Push [BANK OPT] again to go back to the original level
L To turn the function ON or OFF using the HM-133V,
push [BANK/OPTION]
TIP: Changing the volume level when the function
is turned ON
• When rotating [VOL], the function is turned OFF,
and the volume level is changed to the value
corresponding to the [VOL] level
• When [VOL▲ 0 TONE-2] or [VOL▼
on the HM-133V is pushed, the function is turned
OFF, and the volume level goes up or down from
the set value
MUTE
NAR
MID
LOW
LOCK
S ET
When "TVo" (Temporary Volume/Option) is selected in
the [BANK OPT] key item
NAR
MID
LOW
S ET
The Temporary volume item
TONE-1]
1-5
DIGITAL PRIO AO BUSY
ANM
MONI
AO
ANM
MONI
Push [BANK OPT]
"VOL" is displayed
The changed volume level is displayed