Protective Clothing; Work Rules - KTM 1290 Super Adventure S Owner's Manual

2 SAFETY ADVICE
2.7
In the interest of your own safety, KTM recommends that you only operate the vehicle while wearing protective
clothing.
2.8
Unless specified otherwise, the ignition must be turned off during all work (models with ignition lock, models
with remote key) or the engine must be at a standstill (models without ignition lock or remote key).
Special tools are necessary for certain tasks. The tools are not a component of the vehicle, but can be ordered
using the number in parentheses. Example: bearing puller (15112017000)
During assembly, use new parts to replace parts which cannot be reused (e.g. self-locking screws and nuts, seals,
sealing rings, O-rings, pins, and lock washers).
In the case of certain screws, a screw adhesive (e.g. Loctite
tions.
If thread locker (e.g., Precote
After disassembly, clean the parts that are to be reused and check them for damage and wear. Change damaged
or worn parts.
After completing a repair or service work, check the operating safety of the vehicle.
16

Protective clothing

Warning
Risk of injury Missing or poor protective clothing presents an increased safety risk.
–
Wear appropriate protective clothing such as helmet, boots, gloves as well as trousers and a jacket
with protectors on all rides.
–
Always wear protective clothing that is in good condition and meets the legal regulations.

Work rules

® ) has already been applied to a new part, do not apply any additional thread locker.
® ) is required. Observe the manufacturer's instruc-