Table of Contents
Advertisement
3.6.11 IRQ [3-7,9-15], NMI
When this item is enabled, any activity through the system interrupt request lines 3-7, 9-15 and the non-
masked interrupt can reset power-saving mode timeouts to zero, or resume the system from a power-saving
mode.
3.6.12 IRQ 8 Break Suspend
When this item is enabled, any activity through the system interrupt request lines 8 can reset power-saving
mode timeouts to zero, or resume the system from a power-saving mode. IRQ 8 is normally used by the
system real time clock.
3.6.13 Ring Power Up Control
The option lets you specify enable or disable external Modem Wake Up function. The function of power on
through modem when system is off.
Please set the item to "Enabled" then let the system to enter the environment of DOS or Windows 95/98 OS
before system is power off. As long as there are any message through the Modem to enter the System during
system is power off. The system will enable power on function.
3.6.14 MACPME Power Up Control
This allows you to remotely power up your system through your network by sending a wake-up frame or
signal. With this feature, you can remotely upload/download data to/from systems during off-peak hours.
Set to Enabled to set this feature and make sure your system has an ATX power supply with at least 720mA
+5V standby power.
3.6.15 PCIPME Power Up Control
If this item is set as Enabled, PCI peripherals drive PME (Power Management Event) signal to wake the system
from low-power states S1-S5.
3.6.16 Power Up by Alarm
Set this option to enable or disable the RTC Alarm to Wake Up the system which is set at soft Off.
3.6.17 Month Alarm, Date (of Month) Alarm, Time (hh:mm:ss) Alarm
Set these options to specify the RTC Alarm time on Month/Date / Hour / Minute / Second.
3.7 PNP/PCI Configurations Setup
x IRQ Resources
3.7.1 Reset Configuration Data
Figure 3.7 PNP/PCI CONFIGURATIONS SETUP
CMOS Setup Utility - Copyright ( C ) 1984 - 2000 Award Software
Reset Configuration Data
Resources Controlled By
PCI/VGA Palette Snoop
¯ ® ¬: Move
Enter : Select
F5 : Previous Value
PnP / PCI Configurations
Disabled
Auto (ESCD)
Press Enter
Disabled
+/-/PU/PD : Value F10 : Save ESC : Exit F1 : General Help
F6 : Fail-Safe Defaults
F7 : Optimized Defaults
Item Help
Menu Level >
Advertisement
Table of Contents
