Table of Contents
Advertisement
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
X UR2 Duplex Mode
Onboard Parallel Port
Parallel Port Mode
X ECP Mode Use DMA
Game Port Address
Midi Port Address
Midi Port IRQ
¯ ® ¬: Move
3.5.12 Onboard FDC Controller
Select "Enabled" to activate the on-board FDC
Select "Disabled" to activate an add-on FDC
3.5.13 Onboard Serial Port 1 & 2
Select an address and corresponding interrupt for the first/second serial port. The default value for the first
serial port is "3F8/IRQ4" and the second serial port is "2F8/IRQ3".
3.5.14 UART Mode Select & UR2 Duplex Mode
This item defines the operation of serial port 2. In the Normal setting, serial port 2 is assigned to the
external COM2 connector. If you have installed an optional infrared port, you must change the setting of
this item to one of the Infrared settings (usually IrDA). These settings will disable the external COM2 serial
port connector and assign the resources to the infrared device. If you have selected an IR mode, use the
following item UR2 Duplex Mode to define if the IR port is full duplex or half duplex.
3.5.15 Onboard Parallel Port
Select address and interrupt for the Parallel port.
3.5.16 Parallel Port Mode
Select an operating mode for the parallel port. Mode options are SPP, EPP, ECP and ECP+EPP.
3.5.17 ECP Mode Use DMA
Select a DMA channel if parallel port is set as ECP or ECP+EPP.
3.5.18 Game Port Address
This field sets the address of the onboard game port connector.
3.5.19 Midi Port Address
This field is used to select the midi port's address. If you have selected the midi port's address, you may
select its IRQ in the " Midi Port IRQ ".
3.5.20 Midi Port IRQ
Enabled
3F8 / IRQ4
2F8 / IRQ3
Normal
Half
378 / IR7
SPP
3
201
330
10
Enter : Select
+/-/PU/PD : Value F10 : Save ESC : Exit F1 : General Help
F5 : Previous Value
F6 : Fail-Safe Defaults
Item Help
Menu Level >
F7 : Optimized Defaults
Advertisement
Table of Contents
