Taiwan Commate Computer Inc. S630MA Quick Installation page 23

S3 (STR): Enables the STR function.
3.6.3 Video Off Option
When enabled, this feature allows the VGA adapter to operate in a power saving mode.
Always On
Suspend --> Off
Susp,Stby --> Off
All Modes --> Off
3.6.4 Video Off Method
This field defines the video off features. The following options are available: DPMS Supported, Blank
Screen, V/H SYNC+Blank. The DPMS (Display Power Management System) features allow the BIOS to
control the video display card if it supports the DPMS feature.
3.6.5 Switch Function
This item defines if pressing the power switch will cause the system to wake up from suspend or standby
mode.
3.6.6 MODEM Use IRQ
This item tells the Power Management BIOS which IRQ is assigned to the installed MODEM. Option are
NA, 3, 4, 5, 7, 9, 10 and 11.
3.6.7 Power Button Override
Under ACPI (advanced configuration and power interface ) the system can be turned off mechanically ( by
the power button ) or it can undergo a software power off. If the system has been turned off by software, the
system can be resumed by a Alarm wake up signal. This item allows you to define a software power off
using the power button. If the value is set to Instant-Off, the power button will automatically cause a
software power off. If the value is set to Delay 4 Sec. The power button must be held down for a full four
seconds to cause a software power off.
3.6.8 PM Wake Up Events
IRQ [3-7, 9-15], NMI
IRQ 8 Break Suspend
Ring Power Up Control
MACPME Power Up Control
PCIPME Power Up Control
Power Up by Alarm
x Month Alarm
x Date of Month Alarm
x Time ( hh:mm:ss ) Alarm
¯ ® ¬: Move
Monitor will remain on during power saving modes.
Monitor blanked when the systems enters the
Suspend mode.
Monitor blanked when the system enters either
Suspend or Standby modes.
Monitor blanked when the system enters any power
saving mode.
CMOS Setup Utility - Copyright ( C ) 1984 - 2000 Award Software
PM Wake Up Events
Enter : Select +/-/PU/PD : Value F10 : Save ESC : Exit F1 : General Help
F5 : Previous Value F6 : Fail-Safe Defaults
Enabled
Disabled Menu Level >
Disabled
Disabled
Disabled
Disabled
NA
0
0 0 0
F7 : Optimized Defaults
Item Help