Floppy Disk Drive Connector; Primary/Secondary Ide Connector; Ps/2 Mouse Port - Taiwan Commate Computer Inc. S630MA Quick Installation

module onto Infrared connector and configure the setting through
to select whether UART is directed for use with COM2 or Infrared.
2.4.4 Floppy Disk Drive Connector (34-pin FLOPPY)
This connector supports the provided floppy disk drive ribbon cable. Orient the red stripe to pin 1
2.4.5 Primary/Secondary IDE Connector (Two 40-pin IDE)
These connectors support the provided IDE hard disk ribbon cable. Connect your first IDE hard disk to master
mode of the primary channel. If you have second IDE device to install in your system, connect it as slave mode on
the same channel, and the third and fourth device can be connected on secondary channel as master and slave mode
respectively.
There are three connectors on the 80-pin IDE ribbon cable. The blue connector must connect with
motherboard's IDE connector and the other connectors must connect with HDD. In order to get the better
performance the Ultra DMA 66 HDD must connect with 80-pin IDE ribbon cable.
2.4.6 PS/2 Mouse Port (6-pin Mini-Din MS)
The system will direct IRQ12 to the PS/2 mouse.
" "
UART Mode Select in Integrated Peripherals