Taiwan Commate Computer Inc. S630MA Quick Installation page 16

device.
3.3.7 Swap Floppy Drive
When enabled, physical drive A will be assigned to logical drive B, and physical drive B will be assigned to
logical drive A.
3.3.8 Boot Up Floppy Seek
The system will detect and verify operation of the floppy drive type.
3.3.9 Boot Up Numlock Status
The option allows the <NumLock> key to be activated after system boot up.
3.3.10 Gate A20 Option
This entry allows you to select how the gate A20 is handled. The gate A20 is a device used to address
memory above 1 Mbytes. Initially, the gate A20 was handled via a pin on the keyboard (Normal). Today,
while keyboards still provide this support, it is more common, and much faster, for the system chipset (Fast;
default) to provide support for gate A20.
3.3.11 Typematic Rate Setting
Select "Enabled" to configure "Typematic Rate" and "Typematic Delay" functions.
3.3.12 Typematic Rate
Use this option to set the rate at which a character keeps repeating while you hold down a key.
3.3.13 Typematic Delay
Select "Enabled" to set the length of delay before key strokes to repeat. Available options are "250", "500",
"750", and "1000".
3.3.14 Security Option
You can select whether the password is required every time the system boots or only when you enter the
Setup. You can assign "Set Password" in the main CMOS Setup Utility Screen.
3.3.15 OS Select for DRAM > 64MB
If you are using OS/2 operating system and installed memory is larger than 64MB. You need to have the
setting in the enable mode.
3.3.16 HDD S.M.A.R.T. Capability
The item allows you to set HDD S.M.A.R.T. Capability function. Configuration options: Enabled and
Disabled.
3.3.17 Report No FDD For WIN 95
While the FDD in " STANDARD CMOS SETUP " is set to NONE, set this option to No to release IRQ6 for
passing Win95 logo. This option is irrelevant under normal operation.