Table of Contents
Advertisement
¯ ® ¬: Move
3.5.2 Internal PCI/IDE
Use this item to enable or disable the PCI IDE channels that are integrated on this motherboard.
3.5.3 IDE Primary & Secondary Master/Slave PIO
These four PIO fields let you set a PIO mode (0-4) for each of four IDE devices. When under "Auto" mode,
the system automatically set the best mode for each device
3.5.4 IDE Primary & Secondary Master/Slave UDMA
When set to "Auto" mode, the system will detect if the hard drive supports Ultra DMA mode.
3.5.5 IDE Burst Mode
Use this item to enable a buffer for bus master PCI IDE transfers.
3.5.6 SIS 630 OnChip PCI Device
SIS-7018 AC97 AUDIO
SIS-7013 S/W Modem
SIS-900 10/100M ETHERNET
SIS-900 MAC Address Input
¯ ® ¬: Move
3.5.7 SIS-7018 AC97 AUDIO
This item enables the integrated audio capabilities.
3.5.8 SIS-7013 S/W Modem
This item enables the integrated software modem capabilities.
3.5.9 SIS-900 10/100M ETHERNET
This item enables the integrated Ethernet capabilities.
3.5.10 SIS-900 MAC Address Input
The address was set OK by manufacturer. If the data is lost, system will prompt you to key in the address
number. Please follow the address number sticker that on motherboard to key in the number.
3.5.11 SIS 950 SuperIO Device
Enter : Select
+/-/PU/PD : Value F10 : Save ESC : Exit F1 : General Help
F5 : Previous Value
F6 : Fail-Safe Defaults
CMOS Setup Utility - Copyright ( C ) 1984 - 2000 Award Software
SIS 630 OnChip PCI Device
Enter : Select
+/-/PU/PD : Value F10 : Save ESC : Exit F1 : General Help
F5 : Previous Value
F6 : Fail-Safe Defaults
CMOS Setup Utility - Copyright ( C ) 1984 - 2000 Award Software
SIS 950 SuperIO Device
F7 : Optimized Defaults
Enabled
Disabled
Menu Level >
Enabled
Press Enter
F7 : Optimized Defaults
Item Help
Advertisement
Table of Contents
