11.12 Water pressure during WaveClean too low
Description
Description This fault message is displayed if the pressure switch registered a
Troubleshooting Ensure on-site water supply to soft water connection of unit. The
Troubleshooting
water pressure that is too low during WaveClean's. The program is
stopped until the water pressure is sufficiently high again.
supply pressure on the water connection must be at least 2 bar. If the
fault occurs sporadically, check the on-site water pressure while
observing nearby water consumers.
Ensure customer-supplied water supply on the soft water connection
of unit. The supply pressure on the water connection must be at least
2 bar. If the fault occurs sporadically, check the on-site water
pressure while observing nearby water consumers.
Service-instructions
Error messages
69