Husqvarna R 418TsX AWD Operator's Manual page 95

• Pull the PTO button out to engage the drive to the
blades or other equipment.
• Push the PTO button in to disengage the drive to the
blades or other equipment.
Weight transfer function
The weight transfer function moves weight from
the accessory to the product. The ground pressure
increases on the front wheels of the product and
decreases the ground pressure on the pivot wheels.
Set the weight transfer function to on for best cutting
result when you cut grass, also when using sweeper.
During snow clearing Husqvarna recommends that the
weight transfer function is off to apply maximum ground
pressure on the accessory. The equipment frame cannot
be lowered fully if the weight transfer function is on.
WARNING:
the weight transfer function must be set to
off when you change accessories.
Headlights
The headlight has work light and high beam light.
Push the power switch to make the work lights come on
(B) or go off (A). Push the power switch to make the
high beam light and the work light come on (C) or go off
(A).
A
The work light stays on for 3 minutes after the ignition
is switched off. When the headlights are on, the display
shows the headlight symbol. Refer to
97 .
880 - 009 - 31.10.2022
To prevent crush injuries,
B
C
Display on page
Power outlet
The product has 2 power outlets. The power outlet on
the right side control panel by the the seat has a voltage
of 12 V.
The power outlet in the engine housing has a voltage of
12 V.
• Push the power switch (A) to set the power outlet on
the right side control panel to on or off.
• Push the power switch (B) to set the power outlet in
the engine housing to on or off.
A
Function switch for the rear power
outlet
The function switch (A) is used to operate some of
the approved accessories connected to the rear power
outlet. The function switch has different functions on
B
95