Husqvarna R 418TsX AWD Operator's Manual page 116

1. Connect one end of the red cable to the POSITIVE
battery terminal (+) on the weak battery (A).
B
A
2. Connect the other end of the red cable to the
POSITIVE battery terminal (+) on the fully charged
battery (B).
WARNING:
the ends of the red cable against the
chassis.
3. Connect one end of the black cable to the
NEGATIVE battery terminal (-) on the fully charged
battery (C).
4. Connect the other end of the black cable to a
CHASSIS GROUND (D), away from the fuel tank
and the battery.
To remove the jumper cables
Note:
Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
Tire pressure
Make sure to have the correct tire pressure on all 4 tires.
Technical data on page 129 .
Refer to
116
C
D
Do not short circuit
To put the cutting deck in the servicing
position
1. Do the steps 1–7 in
page 104 .
2. Pull and hold the lock handle.
3. Hold the front edge of the cutting deck and pull
forward while you hold the lock handle. Pull the
cutting deck to the end position.
Note:
If you can not pull the cutting deck to its end
position, release the lock handle and pull it up again.
4. Lift the cutting deck to vertical position until a
click sound is heard. The cutting deck is locked
automatically in the vertical position.
5. Carefully pull the front edge of the cutting deck
forward, to make sure that the cutting deck is locked.
To attach the cutting deck on
880 - 009 - 31.10.2022