Husqvarna R 418TsX AWD Operator's Manual page 114

Examine and adjust the steering as follows:
1. The steering wires are correctly tightened if you can
manually move them 5 mm up or down in the groove
on the steering collar.
2. If the wires are too loose, let an authorized service
agent adjust them.
To do a check of the parking brake
1. Park the product on a hard surface that slopes
maximum 10°.
Note:
Do not park the product on a grass slope
when you do a check of the parking brake.
2. Press the parking brake pedal down (1).
3. Press and hold the lock button (2) and release the
parking brake pedal while the button is pressed.
1
4. If the product starts to move, let an approved service
agent adjust the parking brake.
5. Press the parking brake pedal again to release the
parking brake.
To replace the fuel filter
1. Use a pair of flat pliers to move the hose clips away
from the filter.
2. Pull off the filter from the hose ends.
114
2
3. Press the new filter into the ends of the hoses. Apply
liquid detergent to the ends of the filter to make the
connection easier.
4. Push the hose clips against the filter.
To clean and change the air filter
1. Open the engine cover.
2. Loosen the 2 knobs that hold the air filter cover and
remove it.
3. Loosen the hose clip that holds the air filter cartridge.
4. Remove the air filter cartridge from the filter housing.
5. Remove the foam rubber filter around the air filter
cartridge.
6. Clean the foam rubber filter with a weak detergent.
7. Let the foam rubber filter become fully dry.
8. Hit the paper filter against a hard surface to clean it.
Do not use compressed air.
9. If the paper filter does not become clean, replace it.
880 - 009 - 31.10.2022