Husqvarna R 418TsX AWD Operator's Manual page 119

17. Turn the adjustment screw (B) on the cutting height
chain until the bearing wheel (C) touches the
lever(D).
C
18. Tighten the locknut on the stretching screw.
19. Do a check of the parallelism. Refer to
check of the parallelism of the cutting deck on page
117 .
20. Attach the right footrest plate.
To remove the BioClip plug
• Remove the BioClip plug to change a Combi cutting
deck from BioClip to rear discharge of the grass.
To remove and attach the BioClip plug on the
cutting deck Combi 103, Combi 112, Combi
122
1. Put the cutting deck in servicing position. Refer to
put the cutting deck in the servicing position on page
116 .
2. Remove the 3 screws that hold the BioClip plug and
remove the plug.
3. Attach 3 M8x15 mm screws in the screw holes for
the BioClip plug to prevent damage to the threads.
4. Put the cutting deck in the mow position.
5. Attach the BioClip plug in the opposite sequence.
To examine the blades
CAUTION:
balanced blades can cause damage to the
product. Replace damaged blades. Let an
880 - 009 - 31.10.2022
D
To do a
Damaged or incorrectly
approved service agent help you sharpen
and balance blunt blades.
1. Put the cutting deck in servicing position.
2. Look at the blades to see if they are damaged and if
it is necessary to sharpen them.
3. Tighten the blade bolts with tightening torque 75-80
Nm.
To replace the blades
1. Put the cutting deck in servicing position.
2. Lock the blade with a wooden block (A).
C
To
3. Loosen and remove the blade bolt (B), the washers
(C) and the blade (D).
4. Assemble the new blade with the ends that have an
angle in the direction of the cutting deck.
WARNING:
can cause objects to eject from the
cutting deck and cause serious injury.
Use only the blades given in
data on page 129 .
5. Attach the blade, the washer and the bolt. Tighten
the bolt with a torque of 75-80 Nm.
To do a check of the engine oil level
1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
B
D
A
Incorrect blade type
Technical
119