Husqvarna R 418TsX AWD Operator's Manual page 118

8. Loosen the locknuts on the lift stay.
9. Turn the adjustment nut on the lift stay to adjust the
length of the lift stay. Increase the length to lift the
rear edge of the cover. Decrease the length to lower
the rear edge of the cover.
10. Tighten the locknuts on the lift stay when the length
of the lift stay is correct.
11. Loosen the locknut (A) on the clevis joint on the
height adjustment stay. Turn the clevis joint (B) on
the height adjustment stay to adjust the length of
the height adjustment stay. Make sure that the clevis
joints align with the correct hole on the frame of the
cutting deck.
Note:
The 2 ends of the height adjustment stay
each have a clevis joint. You get the same result
independently of which clevis joint you adjust.
118
A
B
12. Use the middle hole (A) on the frame in the cutting
deck.
13. Tighten the locknut on the height adjustment stay
when the length of the height adjustment stay is
correct.
14. Move the cutting height lever to the cutting height
position 1.
15. Remove the right footrest plate. Refer to
and install the right footrest plate on page 113 .
16. Loosen the locknut (A) on the stretching screw of the
cutting height chain.
A
To remove
A
B
880 - 009 - 31.10.2022