Husqvarna R 418TsX AWD Operator's Manual page 121

12. Fill with oil to compensate for the oil held in the new
oil filter.
To do a check of the transmission oil
level
WARNING:
check when the transmission is cool.
1. Remove the 2 screws, and remove the transmission
cover.
2. Make sure that the oil level in the transmission oil
tank is between the 2 horizontal lines on the tank.
3. Fill with engine oil if the oil level is below the lower
line, but do not fill above the top line. Refer to
Technical data on page 129 for recommended oil.
Lubrication, general information
• Remove the ignition key to prevent accidental
movements during lubrication.
• Clean the area before you lubricate a part on the
product.
• Use engine oil when you lubricate with an oil can.
• When you lubricate with grease, use a chassis or
ball bearing grease that prevents corrosion. Remove
unwanted grease after lubrication.
• Lubricate 2 times a week if you operate the product
daily.
• Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean with
alcohol. If the friction between the drive belt and the
880 - 009 - 31.10.2022
Do the transmission oil
Max
Min
pulley is not sufficient after you clean with alcohol,
replace the drive belt.
CAUTION:
petroleum products to clean drive belts.
To lubricate the throttle cable, choke
cable and lever bearings
1. Remove the right side cover.
2. Open the engine cover.
3. Lubricate the free ends of the cables, including the
ends near the engine, with engine oil.
4. Move the throttle control, choke control and the
controls for the cutting deck to their end positions
and lubricate the cables again.
5. Lubricate the joints, catches, bearings and chain of
the controls for the cutting deck with engine oil.
6. Attach the right side cover.
To lubricate the chains in the frame
tunnel
1. Remove the 4 screws and remove the frame tunnel
cover.
Do not use gasoline or other
121