Husqvarna R 418TsX AWD Operator's Manual page 108

3. If the engine is cold, move the choke control fully
rearward.
4. Turn the ignition key to the start position.
5. When the engine starts, immediately release the
ignition key to the neutral position.
Note:
Do not keep the ignition key in the start
position for more than 5 seconds at a time. If the
engine does not start, wait 15 seconds before you try
again.
6. Let the engine run at half throttle for 3-5 minutes
before you apply heavy load.
7. Push the throttle control to the full throttle position.
To operate the product
1. Start the engine. Refer to
page 107 .
2. Release the parking brake.
108
To start the engine on
3. Carefully push down one of the speed pedals. The
speed increases the more the pedal is pushed down.
Use pedal (A) to move forward, and pedal (B) to
move rearward.
4. Release the pedal to brake.
5. Select cutting height (1–7) with the cutting height
lever.
6. Move the lift lever forward to lower the cutting deck
to mow position.
7. Pull the PTO button to engage the drive on the
blades.
To stop the engine
1. Push the PTO button to disengage the drive on the
cutting deck blades.
A
B
880 - 009 - 31.10.2022