Installation; Unboxing The Scanner; Setting Up Your Scanner - Kodak E1030 Series User Manual

2 Installation

Unboxing the scanner

Setting up your scanner

A-61997 1 August 2022
The following is a list of steps you will need to perform in order to get
your scanner set up and connected to your computer.
1. Unbox your scanner.
2. Set up your scanner for the first time.
3. Install driver software.
4. Verify scanner driver version.
5. Optionally install available KODAK scanning software.
If you need additional assistance with any scanner issues, go to the
troubleshooting website for your scanner model:
E1030:
AlarisWorld.com/go/E1030-troubleshooting
E1040:
AlarisWorld.com/go/E1040-troubleshooting
Follow these steps to unbox your scanner and get it ready to be set up.
1. Open the scanner box.
2. Remove all the contents from the scanner box.
3. Remove all the shipping tape from the scanner. Open the scanner
cover and remove shipping tape and foam insert
4. Find the Installation Guide and open it.
5. Verify the contents of scanner box. (Refer to left panel of the
Installation Guide.)
Follow these steps from the Installation Guide.
1. Install the input tray.
2. Attach the correct AC plug adapter to the power supply. Attach the
power supply to the scanner, and then to a power outlet.
NOTE: Do not attach any other cables to the scanner at this time
(e.g. USB). You will be instructed when to do that, at the proper
time.
3. Turn the scanner on by pressing the power button
of the scanner.
2 Installation
on the front
9