Table of Contents
Advertisement
2 Installation
Unboxing the scanner
Setting up your scanner
A-61931 April 2021
The following is a list of steps you will need to perform in order to get
your scanner set up and connected to your computer.
1. Unbox your scanner.
2. Set up your scanner for the first time.
3. Install driver software.
4. Verify the scanner's firmware.
5. Optionally update scanner's firmware.
6. Optionally install available Kodak scanning software.
NOTE: When installing updates, update the driver software before
updating the scanner's firmware.
If you need additional assistance with any scanner issues, go to the
troubleshooting website for your scanner model:
S2040/S2050/S2070:
www.alarisworld.com/go/S2000-troubleshooting
S2060w/S2080w:
www.alarisworld.com/go/S2000w-troubleshooting
Follow these steps to unbox your scanner and get it ready to be set up.
1. Open the scanner box.
2. Remove all the contents from the scanner box.
3. Remove all the shipping tape from the scanner.
4. Find the Installation Guide and open it.
5. Verify the contents of scanner box. (Refer to left panel of the
Installation Guide.)
Follow these steps from the Installation Guide.
1. Install the input tray.
2. Attach the correct AC plug adapter to the power supply. Attach the
power supply to the scanner, and then to a power outlet.
NOTE: Do not attach any other cables to the scanner at this time
(e.g. USB). You will be instructed when to do that, at the proper
time.
3. Turn the scanner on by pressing the power button
of the scanner.
on the front
9
Advertisement
Table of Contents
