Lexus RCF 2022 Owner's Manual page 82

80
2-1. Instrument cluster
Brake fluid pressure
E
Steering amount
F
Sub-content display area

G-force direction
A
Current G-force value (analyzed
B
value of front/rear and left/right
G-forces)
This display is intended for use as a guide-
line. Depending on factors such as the road
surface condition, temperature and vehicle
speed, the display may not show the actual
condition of the vehicle.
 Switching the display
To switch to advanced display, press
To return to normal display, press
 Resetting the record of maximum
G-forces
With the record of maximum G-forces dis-
played, press and hold
play.
 Peak hold function (advanced dis-
play only)
If lateral G-forces of 0.5 G or greater are
generated, the G-force value displayed on
the sub-content display area will turn yel-
low and be held for 3 seconds.
■
Displays the raised/retracted state of
the active rear wing
■
If the engine is stopped while a lap is being
timed, the lap timer will stop and the lap
time up to that point will be recorded.
■
Torque distribution may not be displayed
correctly in some cases, such as when the
vehicle passes over road expansion joints.
■
●
.
●
.
to reset the dis-
●
●
Rear wing position (vehicles with
an active rear wing)
Using the lap timer
Torque distribution display (if equipped)
G-force display
The G-force values may not be zero even
when the vehicle is parked, such as when
it is parked on an incline.
The steering amount, accelerator pedal
input, and brake fluid pressure displays
are disabled until the engine has warmed
up (the variable red zone of the tachome-
ter has retracted to 7300 rpm).
After the engine has warmed up, these
displays will be enabled.
Depending on the vehicle usage condi-
tions, the brake fluid pressure display may
not reach its maximum reading even
though the brake pedal is fully depressed.
If a battery terminal is disconnected and
reconnected, the steering amount display
may be disabled temporarily. After driv-
ing the vehicle for a while, the display will
be enabled.