194
4-5. Using the driving support systems
The control standby state will be entered
and the engine speed will be automatically
maintained between 1500-2000 rpm.
If the "LAUNCH" indicator turns off,
release the accelerator pedal and perform
this procedure again from 6.
8
Within 3 seconds of depressing the
accelerator pedal, release the
brake pedal to start off.
The "LAUNCH" indicator will turn off 3
seconds after the accelerator pedal is
depressed.
If the brake pedal is not released before the
"LAUNCH" indicator turns off, release the
accelerator pedal and perform this proce-
dure again from 6.
After starting off, when the accelerator
pedal is released, launch control will stop
operating.
Canceling launch control
■
Perform any of the following:
Shift the shift lever to any position
other than D.
Operate the drive mode switch to
select any mode other than SPORT
S+ mode.
Press the
Press the "LAUNCH" switch.
Operation condition
■
When all of the following conditions are
met, launch control can be enabled:
The engine and transmission are suffi-
●
ciently warmed up.
●
The engine, transmission, driving support
systems, etc. are not malfunctioning.
Launch control will not operate prop-
■
erly when
In the following situations, launch control
may not operate properly:
When the brake pedal is not firmly
●
depressed and the rear wheels slip.
switch.
When starting off on a road surface that
●
is wet with rain, standing water, etc.
●
When starting off on a slick road surface.
When the vehicle has not been properly
●
maintained (tires are worn out, tire pres-
sure is low, etc.).
WARNING
Launch control precautions
■
Observe the following precautions.
Failure to do so may result in death or
serious injury.
●
Do not use on public roads.
●
Use only when road and ambient con-
ditions are safe.
●
Before use, ensure that no people or
obstructions are nearby.
●
Proper use of launch control requires
an expert level of driving skill. When
using launch control, always check the
track conditions and surrounding area.
●
Do not start off with the rear wheels
spinning.
NOTICE
To avoid damage to the vehicle when
■
using launch control
●
As launch control applies a large load
on vehicle components, do not use it
excessively.
●
Always follow the correct operation
procedures as described in this man-
ual.
●
Only use launch control on dry, paved
roads, as slippery or loose road sur-
faces may cause damage to the vehi-
cle.
●
When using launch control repeatedly,
wait approximately 10 minutes
between each use.