Table of Contents
Advertisement
72
2-1. Instrument cluster
changed suddenly (at the entrance/exit of
a garage, tunnel, etc.)
●
When "_ _" or "E" is displayed, the system
may be malfunctioning.
Take your vehicle to your Lexus dealer.
Pop-up display
■
In some situations, such as when a switch
●
operation is performed, a pop-up display
will be temporarily displayed on the
multi-information display.
Some pop-up displays can be set on/off.
●
(P.81)
Liquid crystal display
■
Small spots or light spots may appear on the
display. This phenomenon is characteristic
of liquid crystal displays, and there is no
problem continuing to use the display.
Customization
■
The meter display can be customized on
the multi-information display. (P.358)
WARNING
■
The information display at low tem-
peratures
Allow the interior of the vehicle to warm
up before using the liquid crystal infor-
mation display. At extremely low tem-
peratures, the information display
monitor may respond slowly, and display
changes may be delayed.
For example, there is a lag between the
driver's shifting and the new gear number
appearing on the display. This lag could
cause the driver to downshift again,
causing rapid and excessive engine brak-
ing and possibly an accident resulting in
death or injury.
NOTICE
To prevent damage to the engine and
■
its components
●
Do not let the indicator of the tachom-
eter enter the red zone, as it rep-
resents the engine speed range which
exceeds the maximum safe engine
speed.
●
In the following situations, the engine
may be overheating. In this case,
immediately stop the vehicle in a safe
place, and check the engine after it has
cooled completely. (P.336)
• The engine coolant temperature
gauge indicator (
zone and flashing.
• The engine oil temperature gauge
indicator (
) is in the red zone and
flashing.
Odometer and trip meter dis-
play
Display items
■
Odometer
Displays the total distance the vehicle has
been driven.
Trip meter A/trip meter B
Displays the distance the vehicle has been
driven since the meter was last reset. Trip
meters A and B can be used to record and
display different distances independently.
To reset, display the desired trip meter and
press and hold the odometer/trip meter
and trip meter reset button.
Changing the display
■
Each time the "ODO TRIP" switch is
pressed, the displayed item will be
changed. When the trip meter is dis-
played, pressing and holding the switch
) is in the red
Advertisement
Table of Contents
