Table of Contents
Advertisement
■
Before programming
Install a new battery in the transmitter.
●
●
The battery side of the transmitter must
be pointed away from the HomeLink
Operating HomeLink
Press the appropriate HomeLink
button. The HomeLink
should turn on.
The status of the opening and closing
of a garage door is shown by the indi-
cators.
Opening
A
Closing
B
This function is only available if the garage
door opener motor used is a compatible
device. (To check device compatibility,
refer to www.homelink.com.)
Color
Orange (flashing)
Green
Red (flashing)
The indicators can operate within
approximately 820 ft. (250 m) of the
5-5. Using the other interior features
®
.
®
®
®
indicator light
Status
Currently open-
ing/closing
Opening/closing has
completed
Feedback signals
cannot be received
garage door. However, if there are
obstructions between the garage door
and the vehicle, such as houses and
trees, feedback signals from the
garage door may not be received.
To recall the previous door operation
status, press and release either
®
HomeLink
buttons
or
and
neously. The last recorded status will
be displayed for 3 seconds.
Erasing the entire HomeLink
memory (all three codes)
Press and hold the 2 outside buttons
for 10 seconds until the HomeLink
indicator light changes from continu-
ously lit (orange) to rapidly flashing
(green).
If you sell your vehicle, be sure to erase the
programs stored in the HomeLink
ory.
233
and
simulta-
®
5
®
®
mem-
Advertisement
Table of Contents
