ZyXEL Communications XMG1930 Series User Manual page 96

30-port multi-gigabit smart managed layer-2 switch
Hide thumbs Also See for XMG1930 Series:
Table of Contents

Advertisement

Figure 63 Basic Setting > IP Setup > IP Status Details: Static
The following table describes the labels in this screen.
Table 29 Basic Setting > IP Setup > IP Status Details: Static
LABEL
DESCRIPTION
Type
This shows the IP address is manually assigned (Static).
VID
This is the VLAN identification number to which an IP routing domain belongs.
IP Address
This is the IP address of your Switch in dotted decimal notation for example 192.168.1.1.
IP Subnet Mask
This is the IP subnet mask of your Switch in dotted decimal notation for example 255.255.255.0.
Figure 64 Basic Setting > IP Setup > IP Status Details: DHCP
The following table describes the labels in this screen.
Table 30 Basic Setting > IP Setup > IP Status Details: DHCP
LABEL
DESCRIPTION
Type
This shows the IP address is dynamically assigned from a DHCP server (DHCP).
VID
This is the VLAN identification number to which an IP routing domain belongs.
IP Address
This is the IP address of your Switch in dotted decimal notation for example 192.168.1.1.
IP Subnet Mask
This is the IP subnet mask of your Switch in dotted decimal notation for example 255.255.255.0.
Lease Time
This displays the length of time in seconds that this interface can use the current dynamic IP
address from the DHCP server.
Renew Time
This displays the length of time from the lease start that the Switch will request to renew its
current dynamic IP address from the DHCP server.
Rebind Time
This displays the length of time from the lease start that the Switch will request to get any
dynamic IP address from the DHCP server.
Lease Time Start
This displays the date and time that the current dynamic IP address assignment from the DHCP
server began. You should configure date and time in Basic Setting > General Setup.
Lease Time End
This displays the date and time that the current dynamic IP address assignment from the DHCP
server will end. You should configure date and time in Basic Setting > General Setup.
Chapter 8 Basic Setting
XMG1930 Series User's Guide
96

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mg1930-30Xmg1930-30hp

Table of Contents