Table of Contents
Advertisement
50.1 Overview
This chapter introduces the port status screens.
50.2 Port Status
This screen displays a port statistical summary with links to each port showing statistical details. To view
the port statistics, click Status in all Web Configurator screens and then the Port Status link in the Quick
Links section of the Status screen to display the Port Status screen as shown next. You can also click
Management > Port Status to see the following screen.
Figure 262 Management > Port Status
The following table describes the labels in this screen.
Table 191 Management > Port Status
LABEL
Port
Name
Link
State
DESCRIPTION
This identifies the Ethernet port. Click a port number to display the Port Details screen.
This is the name you assigned to this port in the Basic Setting > Port Setup screen.
This field displays the speed (such as 100M for 100 Mbps, 1G for 1000 Mbps or 1 Gbps, 2.5G for 2.5
Gbps, 5G for 5 Gbps, or 10G for 10 Gbps) and the duplex (F for full duplex). This field displays
Down if the port is not connected to any device.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port.
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays STOP.
When LACP (Link Aggregation Control Protocol) and STP are in blocking state, it displays
Blocking.
XMG1930 Series User's Guide
C
H A P T E R
Port Status
365
50
Advertisement
Table of Contents
Troubleshooting
