Component Wiring Diagram - Empire Comfort Systems Boulevard DVLL60BP90K-2 Installation Instructions Manual

Direct-vent zero clearance gas fireplace heater
Table of Contents

Advertisement

COMBUSTION
BLOWER
USER INTERFACE/
TO LIGHTS
BATTERY HOLDER
AUX.
L
N
WHITE
BLACK
BLOWER
POWER CORD
BLACK
WHITE
TO JUNCTION
GREEN
BOX
If any of the original wire as supplied with this fireplace must be
replaced, it must be replaced with equivalent gauge and tem-
perature rated wire.
This fireplace is only for use with the type of gas indicated on the
rating plate and may be installed in an aftermarket, permanently
located, manufactured (mobile) home where not prohibited by
local codes. This fireplace is not convertible for use with other
gases, unless a certified kit is used.
ELECTRICAL GROUNDING INSTRUCTIONS
This fireplace is equipped with a three-prong grounding
plug for your protection against shock hazard and should
be plugged directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding prong from
this plug.
Page 52

COMPONENT WIRING DIAGRAM

ORANGE
WARNING
GREEN
ORANGE
YELLOW
LOOP
WHITE
Label all wires prior to disconnection when servicing controls.
Wiring errors can cause improper and dangerous operation.
Do not operate the fireplace with glass panel removed,
cracked or broken. Replacement of the panel should be
done by a licensed qualified service person.
Improper installation, adjustment, alteration, service or
maintenance can cause property damage, personal injury
or loss of life. Installation and service must be performed
by a qualified installer, service agency or the gas supplier.
Verify proper operation after servicing.
GAS CONTROL VALVE
CAUTION
CAUTION
WARNING
PILOT
WHITE
OR
BLACK
ORANGE
41368-0-0120

Advertisement

Table of Contents
loading

This manual is also suitable for:

Boulevard dvll60bp90n-2Boulevard dvll60bp90p-2

Table of Contents