Fuel Flow Calibration In A Suzuki Engine Interface - Lowrance X510C Operation Instructions Manual

1. Press
MENU| MENU
2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
3. Select the desired EP-15 Fluid Level and press
4. Press ↓ to select
menu will appear.
5. Highlight
N
Make sure your tank is empty, then highlight
6.
. Select
ENT E
MPTY LEVEL
Select
7. C
ALIBRATE
Empty Level Calibration Completed. Press
Add 1 quarter tank of fuel, highlight
8.
1 Q L and press ENT.
TR EVEL
9. Select C
ALIBRATE
Qtr Level Calibration Completed. Press
10. Add another quarter tank of fuel, which should raise the fuel level
to half a tank. Highlight
press
ENT.
Highlight
11.
pear: Half Level Calibration Completed. Press
12. Add another quarter tank of fuel, which should raise the fuel level
to 3 quarters of a tank. Highlight
and press
L
EVEL
Select
13. C
ALIBRATE
Qtr Level Calibration Completed. Press
14. Top off the tank, highlight
and press
L
EVEL
Select
15. C
ALIBRATE
Full Level Calibration Completed. Press
edly to get back to the main display.

Fuel Flow Calibration in a Suzuki Engine Interface

The default calibration for the Suzuki Engine Interface is adequate in
most cases, but if Fuel Used readings are off by more than 3 percent,
calibration is recommended.
To check engine interface accuracy:
Select Fuel Used to be shown as Overlay Data on your unit's main dis-
play. Refer to the Overlay Data segment of this manual for instructions
on how to select Fuel Used data as Overlay Data.
, use ↓ ↑ to select
and press
S
US ETUP
C
ALIBRATE
, press
P ENT
UM TS
and press
and press
and press ENT
F
LUID
and press
C
ALIBRATE
ENT.
and press
ENT.
and press
NMEA 2000
, which will open the Bus Configu-
ENT
and press
ENT
and select
5
ENT.
. The following message will appear:
ENT
ENT
F
LUID
. The following message will appear: 1
ENT
and press
L
EVEL
. The following message will ap-
ENT
F L
LUID EVEL
. The following message will appear: 3
ENT
ENT
F L
LUID EVEL
. The following message will appear:
ENT
ENT
109
and press
.
ENT
. The Device Calibration
. Press .
ENT
F L
LUID
.
and press
L
EVEL
.
. Select
ENT
.
ENT
and press
ENT
.
and press
ENT
, then press
.
ENT
and press
EVEL
. Select
ENT
and
H
ALF LEVEL
. Select
3 Q
TR
. Select
F
ULL
repeat-
EXIT