Advanced Options Menu; Instance; Restore Defaults - Lowrance X510C Operation Instructions Manual

3. Select the fuel flow you want to rename and press . The Device
ENT
Configuration menu will appear with the Device Name dialog box high-
lighted.
and use ↑ ↓, ← → to input the desired name for the fuel
4. Press
ENTER
flow. Press . Press repeatedly to get back to the main display.
ENT EXIT
To select a Location:
, use ↑ ↓ to select
1. Press and press . The
MENU| MENU NMEA 2000 ENT
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight and press , which will open the Bus Configu-
B S ENT
US ETUP
ration menu. A list of network devices will be at the top of the page.
3. Select the desired fuel flow and press . The Device Configuration
ENT
menu will appear.
4. Select and press , which will open the Location menu
L ENT
OCATION
with following options: Port, Center, Starboard and Unknown.
5. Highlight the desired location and press . The following message
ENT
will appear: Are you sure you wish to change this device's configuration?
5. Select and press . Press repeatedly to return to the main
Y ENT EXIT
ES
display.

Advanced Options menu

The Fuel Flow sensor Advanced Options menu contains two categories:
Instance and Restore Defaults.

Instance

The Instance command is intended for use only by experienced NMEA
2000 network technicians. Instance allows network technicians to re-
solve certain electronic probe conflicts. This is most likely to occur if the
network includes LMF-200 or LMF-400 digital gauges, which support
the display of fewer electronic probes than your sonar unit.
If you want to use your unit in a network including one of these digital
gauges, you may need to consult customer service.
You should never need this command if you are connecting your unit to
a network with similar display units and/or a series of electronic
probes.

Restore Defaults

The Restore Defaults command allows you to reset an individual EP-10
Fuel Flow Sensor's settings to factory defaults.
99