Instance; Restore Defaults; To Restore Default Settings; Ep-10 Fuel Flow Configuration - Lowrance X510C Operation Instructions Manual

Instance

The Instance command is intended for use only by experienced NMEA
2000 network technicians. Instance allows network technicians to re-
solve certain electronic probe conflicts. This is most likely to occur if the
network includes LMF-200 or LMF-400 digital gauges, which support
the display of fewer electronic probes than sonar unit. If you want to
use your unit in a network including one of these digital gauges, you
may need to consult customer service.
You should never need this command if you are connecting your unit to
a network with similar display units and/or a series of electronic
probes.

Restore Defaults

The Restore Defaults command allows you to reset an individual EP-35
Temp Sensor's settings to factory defaults. If, for example, you execute
the Restore Defaults command from your Water Temp's Advanced Op-
tions menu, only the settings for the Water Temp will be reset to fac-
tory defaults. Other temps on the network will not be affected.

To restore default settings

1. Press
MENU| MENU
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
3. Select the desired temp sensor and press
tion menu will appear.
4. Highlight
A
5. Select
R
ESTORE
appear: Are you sure you wish to change this device's configuration?
6. Highlight
Y
main display.

EP-10 Fuel Flow Configuration

To input Device Name:
1. Press
MENU| MENU
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
:
, use ↑ ↓ to select
and press
S
US ETUP
O
DVANCED PTIONS
and press
D
EFAULTS
and press
ENT
ES
, use ↑ ↓ to select
and press
S
US ETUP
NMEA 2000
, which will open the Bus Configu-
ENT
and press
ENT
. The following message will
ENT
. Press
EXIT
NMEA 2000
, which will open the Bus Configu-
ENT
98
and press
. The Device Configura-
ENT
.
repeatedly to get back to the
and press
. The
ENT
. The
ENT