Advanced Options Menu; Instance; Restore Defaults; To Restore Default Settings - Lowrance X510C Operation Instructions Manual

Advanced Options menu

The Fuel Flow sensor Advanced Options menu contains two categories:
Instance and Restore Defaults.

Instance

The Instance command is intended for use only by experienced NMEA
2000 network technicians. Instance allows network technicians to re-
solve certain electronic probe conflicts. This is most likely to occur if the
network includes LMF-200 or LMF-400 digital gauges, which support
the display of fewer electronic probes than your sonar unit. If you want
to use your unit in a network including one of these digital gauges, you
may need to consult customer service.
You should never need this command if you are connecting your unit to
a network with similar display units and/or a series of electronic
probes.

Restore Defaults

The Restore Defaults command allows you to reset an individual EP-15
Fluid Level Sensor's settings to factory defaults. If, for example, you
execute the Restore Defaults command from your Gray Water Fluid
Level Advanced Options menu, only the settings for the Gray Water
Fluid Level will be reset to factory defaults. Other fluid levels on the
network will not be affected.

To restore default settings:

1. Press
MENU| MENU
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
3. Select the desired fluid level and press
tion menu will appear.
4. Highlight
A
5. Select
R
ESTORE
appear: Are you sure you wish to change this device's configuration?
6. Highlight
Y
main display.
NOTE:
The Fluid Level Device Configuration menu also contains the Cali-
brate button, but we will address that later in the segment covering
Calibration.
, use ↑ ↓ to select
and press
S
US ETUP
O
DVANCED PTIONS
and press
D
EFAULTS
and press
ENT
ES
NMEA 2000
, which will open the Bus Configu-
ENT
and press
ENT
. The following message will
ENT
. Press
EXIT
102
and press
. The Device Configura-
ENT
.
repeatedly to get back to the
. The
ENT