Fuel Flow Calibration In A Suzuki Engine Interface - Lowrance LCX-112C Operation Instructions Manual

Select
15. C
ALIBRATE
Full Level Calibration Completed. Press
repeatedly to get back to the main display.

Fuel Flow Calibration in a Suzuki Engine Interface

The default calibration for the Suzuki Engine Interface is adequate in
most cases, but if Fuel Used readings are off by more than 3 percent,
calibration is recommended.
To check engine interface accuracy:
Select Fuel Used to be shown as Overlay Data on your unit's main
display. Refer to the Overlay Data segment of this manual for
instructions on how to select Fuel Used data as Overlay Data.
1. After selecting Fuel Used as overlay data, fill up your tank and press
| .
MENU MENU
2. Select
NMEA 2000
3. Highlight
F
press .
ENT
4. Use ↑ ↓ to select the location (Port, Center or Starboard) of the
engine interface you want to calibrate and press
5. Highlight
message will appear: Are you sure you wish to Fill Tank?
6. Select and press
Y
ES
appear: Do you wish to re-calibrate the device?
7. Highlight
N
burn at least five gallons of fuel. Be sure you run only ONE engine
— the engine connected to your engine interface.
9. Fill up your tank again, noting how much fuel you added to the tank.
Compare that number to the Fuel Used figure displayed on the page
you customized. If the amount of fuel you added to the tank and the
fuel used figure are off by more than 3 percent, we recommend the
engine interface be calibrated.
NOTE:
You must use the gauge's Fill Tank command when filling your fuel
tank to keep the engine interface updated with correct information
on the amount of fuel in the tank.
To calibrate a Suzuki Engine Interface:
10. If calibration is necessary, press
press .
ENT
11. Highlight
F
12. Select
T
ANK
connected to the selected engine interface. Press
13. Highlight
and press
and press
M
UEL ANAGEMENT
and press
F T
ILL ANK
ENTER
and press
ENT
O
M
UEL ANAGEMENT
and press
L
OCATION
and press
F T
ILL ANK
. The following message will appear:
ENT
.
ENT
and press
ENT
. The following confirmation
ENT
. The following confirmation message will
. Take your vessel out on the water and
|
MENU MENU
and press
ENT
to choose the location of the tank
ENT
. The following message will
ENT
207
, then press
ENT
. Select
T
ANK
.
ENT
, select
NMEA 2000
.
.
ENT
EXIT
and
L
OCATION
and