Advanced Options Menu - Lowrance LCX-112C Operation Instructions Manual

4. Press and use ↑ ↓, ← → to input the desired name for the temp
ENT
sensor. Press
display.
To select Temp Type:
1. Press
MENU
NMEA 2000 menu will appear with five options: Bus Setup, Fuel
Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight
Configuration menu. A list of network devices will be at the top of the
page.
3. Select the desired temp sensor and press
Configuration menu will appear.
4. Highlight
T
will appear: Water, Outside, Inside, Engine Room, Cabin, Live Well,
Bait Well, Refigeration, Heating System and Unknown.
5. Highlight the desired Temp Type and press
confirmation message will appear: Are you sure you wish to change this
device's configuration?
6. Highlight
Y
main display.

Advanced Options menu

The Temp sensor Advanced Options menu contains two categories:
Instance and Restore Defaults.
Instance
The Instance command is intended for use only by experienced NMEA
2000 network technicians. Instance allows network technicians to resolve
certain electronic probe conflicts. This is most likely to occur if the
network includes LMF-200 or LMF-400 digital gauges, which support the
display of fewer electronic probes than your GPS or sonar/GPS unit. If
you want to use your unit in a network including one of these digital
gauges, you may need to consult customer service.
You should never need this command if you are connecting your unit to a
network with similar display units and/or a series of electronic probes.
Restore Defaults
The Restore Defaults command allows you to reset an individual EP-35
Temp Sensor's settings to factory defaults. If, for example, you execute
the Restore Defaults command from your Water Temp's Advanced
Options menu, only the settings for the Water Temp will be reset to
factory defaults. Other temps on the network will not be affected.
. Press
ENT
, use ↑ ↓ to select
|
MENU
and press
B S
US ETUP
and press
T
EMP YPE
and press
ENT
ES
repeatedly to get back to the main
EXIT
NMEA 2000
ENT
. The following list of Temp Types
ENT
. Press
EXIT
195
and press
, which will open the Bus
ENT
ENT
repeatedly to get back to the
. The
ENT
. The Device
. The following