Hyundai KONA Electric 2023 Owner's Manual page 427

Driver Assistance System
Overtaking Acceleration Assist
Overtaking Acceleration Assist will
operate when the turn signal indicator
is turned on to the left (left-hand drive)
or turned on to the right (right-hand
drive) while Smart Cruise Control is
operating, and the following conditions
are satisfied:
Your vehicle speed is above 40 mph
(60 km/h)
The hazard warning flasher is off
A vehicle is detected in front of your
vehicle
Deceleration is not needed to
maintain distance with the vehicle in
front
When the turn signal indicator is
turned on to the left (left-hand drive)
or turned on to the right (right-
hand drive) while there is a vehicle
ahead, the vehicle may accelerate
road conditions at all times.
Regardless of your states driving
direction, Overtaking Acceleration
Assist will operate when the
conditions are satisfied. When using
the function in states with different
driving direction, always check the
road conditions at all times.
7-70
Smart Cruise Control Display and
Control
Basic function
You can see the status of the Smart
Cruise Control operation in the Driving
Assist view on the cluster. Refer to "View
Modes" section in chapter 4.
Smart Cruise Control will be displayed
as below depending on the status of the
function.
Operating
OTM070245E
When operating
(1) Whether there is a vehicle ahead and
the selected distance level.
(2) Set speed.
(3) Whether there is a vehicle ahead and
the target headway are displayed.
When temporarily canceled
(1) indicator.
(2) The previous set speed is shaded.
Information
The distance of the front vehicle on the
cluster is displayed according to the
actual distance between your vehicle
and the vehicle ahead.
The target distance may vary according
to the vehicle speed and the set
distance level. If the vehicle speed is
low, even though the vehicle distance
have changed, the change of the target
vehicle distance may be small.
Temporarily canceled
OTM070155E