Table 3-1
Plug/terminal
B1/1
B1/2
B1/3
B5/1
B5/2
B5/3
*
3.2
First setting into operation
-
-
-
________________________________________________________________________________________________________________
3969.DOC010102
Repeater Compass
Cable connection of the Repeater Compass
Designation
+ supply voltage
- supply voltage
GND supply voltage
CAN High or Rx+*
CAN LOW or Rx-*
CAN GND*
CAN Bus is automatically terminated after
selection/configuration as the serial interface.
Switch on the Repeater Compass as described in section 2.4.
The Repeater Compass recognizes the course bus interface and adjusts to it
automatically.
For NMEA/CAN operation the Repeater Compass has to be configured.
133-560
3-4
Edition: August 2014