Signals During Operation - Raytheon 133-560 NG011 Operator's And Service Manual

2.6

Signals during operation

During normal operation the heading is indicated by the display and the cards.
In addition to the heading value on the digital display the source of the heading
information is shown with a 3-line display at the top right of the front plate.
The heading source light up green ("Gyro", "Mag" or "Sat").
________________________________________________________________________________________________________________
3969.DOC010102
Repeater Compass
Indications
Valid heading from the gyro, magnetic or satellite compass
(green)
No valid heading
(red)
( )
133-560
- LED lights up green.
- The three-line display shows the heading source.
- LED lights up red
- horizontal lines on the digital display
- after approx. 10s the LED and "Con" are flashing
Please note:
Only if this repeater is configured as "G-AL"

(Heading Serial HSER) the audible alarm signal is active.
- for buzzer off - press
2-8
Comments, notes
key
Edition: August 2014