Table of Contents
Advertisement
2.7.3
Test mode and actual configuration/status information
With the operations described below the test mode is started and by operating the key
essential configurations or status information can be displayed.
For changing configuration see section 2.8.
RS422 (RS232C) Heading Serial Operation (NMEA or course bus)
Operate key 1x
Operate key 2x
_________________________________________________________________________________________________________________
Edition: August 2014
Repeater Compass
133-560
Indications
(yellow)
(yellow)
(yellow)
2-11
Comments, notes
Do not operate the key too long:
-
approx. 3 seconds after test mode
is selected, another mode (-CF-) is
started
Operate key until
- display indicates '8.8.8.8.'
- the cards, the key, the luminous
panels, the three-colour LED,
the three-line display and
the digital display will light up with
maximum brightness.
With configuration of the unit as steering
Repeater Compass an audible signal is
emitted (continuous sound) only when
the Repeater Compass is connected
direct to a gyro compass.
Software status (shown example only)
Selected interface type:
SCI = Serial controlled interface (as shown)
3969.DOC010102
Repeater
Compass
Advertisement
Table of Contents
