Wireless-G PrintServer with Multifunction Printer Support
5. Select the printer connected to the PrintServer. Click Next.
NOTE: If the PrintServer is not listed, click Refresh. If the PrintServer is not found, then follow
these instructions:
1. Disconnect the power adapter from the PrintServer.
2. Wait two seconds, and reconnect the power adapter to the PrintServer.
3. If the PrintServer is not found, then click the checkbox to disable the firewall.
4. Click Refresh again.
6. The Setup Wizard will install the PrintServer's driver and re-install the printer drivers.
Make sure the printer is connected to the PrintServer, and click Next.
Chapter 4: Installing the PrintServer Driver
Installation
Figure 4-3: Select Printer
Figure 4-4: Check Printer Driver
19