Figure 3-5: Connect The Printserver To The Router; Figure 3-6: Connect The Power To The Printserver - Linksys WPSM54G User Manual

Wireless-G PrintServer with Multifunction Printer Support
6. Connect the Ethernet network cable to your router. Connect the other end of the cable to the Ethernet port of
the PrintServer.
(The Ethernet connection is for configuration purposes only. Later you can disconnect the Ethernet network
cable when the PrintServer has connected wirelessly.)
Click Next.
7. Connect the power adapter to the PrintServer and an electrical outlet. Click Next.
IMPORTANT: Make sure you use the power adapter supplied with the PrintServer. Use of a
different power adapter could damage the PrintServer.
NOTE: The PrintServer does not have an on/off power switch. Whenever its power adapter is
plugged into a power supply, the PrintServer is powered on. The PrintServer can be powered
on before, during, or after your network is powered on.
Chapter 3: Installing the PrintServer Using the Setup Wizard
Installation

Figure 3-5: Connect the PrintServer to the Router

Figure 3-6: Connect the Power to the PrintServer

8