Chapter 4: Installing The Printserver Driver; Overview; Installation - Linksys WPSM54G User Manual

Wireless-G PrintServer with Multifunction Printer Support

Chapter 4: Installing the PrintServer Driver

Overview

This section installs the PrintServer's software on your Windows 2000 or XP computers so they can use the
PrintServer for print jobs. (The PrintServer is fully compatible with Windows 2000 and XP.)
HAVE YOU: already set up your printer? Linksys recommends that you set up your printer and
install your printer's driver before you install the PrintServer's driver.
At this point, you must have the following:
• the PrintServer hardware installed on your network. If not, refer to "Chapter 3: Installing the PrintServer Using
the Setup Wizard".
• TCP/IP installed on each of your computers. (TCP/IP is installed by default.)
• an IP address assigned to each of the computers on your network. (In most networks, the network router
assigns IP addresses to the computers on the network.)
• an IP address assigned to the PrintServer by you or your network router. By default the PrintServer has DHCP
enabled so the network router will automatically assign an IP address. If you need to manually assign an IP
address, run the Setup Wizard on the Setup CD-ROM (refer to "Chapter 3: Installing the PrintServer Using the
Setup Wizard").
It is assumed that your CD-ROM drive's letter name is designated as "D". If your CD-ROM drive is named another
letter, replace all instances of "D" with the appropriate letter.

Installation

1. Make sure you have no programs or applications running on your computer.
2. If you haven't already done so, insert the Setup CD-ROM into the computer's CD-ROM drive. The Setup CD-
ROM should run automatically. If it does not, click the Start button and choose Run. In the field that appears,
enter D:\SetupWizard.exe (if "D" is the letter of your CD-ROM drive).
Chapter 4: Installing the PrintServer Driver
Overview
17